Brake Cleaner WD-40 500 ml Powerful degreaser designed for VESPA motorcycle braking systems

WD-40 Brake Cleaner 500 ml Powerful degreaser designed for VESPA motorcycle braking systems The motorcycle is exposed to different climatic conditions and the elements that compose it attract dust, oil and other dirt, which can compromise its perfect functioning. This is particularly true for the braking system: here's how to clean the brake discs of the motorcycle, one of the maintenance operations that should not be overlooked! Correct maintenance and checking the good condition of the brake discs avoids accidents along the way and allows you to travel safely. It is essential to choose the right products and our advice is to use the WD-40 Specialist Moto Brake Cleaner, developed specifically for motorcycle maintenance. The WD-40 Specialist Moto Brake Cleaner is a very powerful degreaser, designed specifically for braking systems. The product is extremely volatile, which means that it dries quickly. It is composed of solvents capable of quickly dissolving grease, dust, oil and other dirt on the brakes. With its high pressure jet and 360 ° valve, it can reach even the most hidden areas. This product effectively removes all residues. In addition to its use on brake discs and calipers, it also effectively degreases the clutch system and the engine block. This product is a must for motorcycle maintenance after the summer! It is ideal for removing salt residues from the braking system. Recommendations for use: never use the product on hot surfaces, decorative elements, plastic or rubber. Materials needed to perform brake maintenance Before starting, make sure you have the necessary equipment available. You will need: Motorcycle stand Oscillation meter Screwdrivers and pliers Brush Brush Soft cloth Drip tray Brake cleaner WD-40 Specialist Moto How to perform brake maintenance on your motorcycle First of all, place the motorcycle on the stand, preferably centrally, to be able to work safely. Position the drip tray under the discs. For better cleaning, remove the wheel and then the caliper with its support without disconnecting the brake fluid lines. At this point, check whether the discs are clean or need replacing. Shake the can of WD-40 Specialist Moto Brake Cleaner well. Then, generously spray the WD-40 Specialist Moto brake cleaner on the discs and calipers and let the fluid flow into the container. Thanks to its very active formula, this product quickly dissolves dust and dirt residue and dries in a few seconds. Rub the elements with a brush: for hard-to-reach corners, use a toothbrush that will clean the area more easily. Finally, remove any excess product with a soft cloth. After completely removing grease and rust, check that there is no more oil and grease on the disc, which would hinder the correct functioning of the pads. Once cleaning is complete, you can reassemble the wheel, following the same steps as for disassembly. At this stage we recommend using a comparator to measure the oscillation of the disc, which must not exceed 0.10 mm. Too much oscillation causes abrasions on the disc. Finally, once the discs have been reassembled, do a road check to verify the correct functioning of your motorcycle. If there are oil leaks, check the tightening of the bolts and the wheel housing carefully. If you have any difficulties, contact your trusted mechanic for further checks!